ATEN KN1108v Manuel d'utilisateur télécharger pdf (Page 269)

Appendix

253

Internal Serial Interface Configuration

The KVM Over the NET™ switch provides a function that lets you configure

an attached device’s serial interface parameters from within any accessed

server. To do so:

1. From the accessed server, open a command line (terminal) session or third

party serial application such as HypterTerminal or PuTTY.

2. Telnet or SSH to the KVM Over the NET™ switch’s IP address.

3. Log in with your usual Username and Password to bring up the access

screen:

Navigation

The left panel shows the KVM Over the NET™ switch at the top, and all the

serial interface devices connected to it listed below. The right panel shows the

configuration parameters at the top, with the configuration settings in the area

below.

 Use the Left and Right Arrow keys (

← and → ) to move the highlight bar

between the right and left panels, and to select the parameter to configure.

 Use the Up and Down Arrow Keys (

↑ and ↓ ) to select among the switch

and the serial devices in the left panel; use them to select the configuration

items in the right panel.

1 2 ... 264 265 266 267 268 269 270 271 272 273 274 ... 283 284

Pas de commentaire

ATEN KN1108v Manuel d'utilisateur Page 269