ATEN KN1108v Manuel d'utilisateur télécharger pdf (Page 222)

KVM Over the NET™ User Manual

206

 Pausing Auto Scan

While you are in Auto Scan Mode, you can pause the scanning in order to

keep the focus on a particular server by pressing P. During the time that

Auto Scanning is paused, the S in front of the Port ID blinks On and Off.

Pausing when you want to keep the focus on a particular server can be

more convenient than exiting Auto Scan Mode because when you Resume

scanning, you start from where you left off. If, on the other hand, you were

to exit and then restart Auto Scan Mode, the scanning would start over

from the very first server on the installation.

To Resume Auto Scanning after a pause, press any key except [Esc] or the

[Spacebar]. Scanning continues from where it left off.

 Exiting Auto Scan

While Auto Scan Mode is in effect, ordinary keyboard functions are

suspended. You must exit Auto Scan Mode in order to regain normal

control of the keyboard. To exit Auto Scan Mode press [Esc] or the

[Spacebar]. Auto Scanning stops when you exit Auto Scan Mode.

Skip Mode

Skip Mode allows you to switch ports in order to monitor the servers manually.

You can dwell on a particular port for as long or as little as you like - as

opposed to Auto Scanning, which automatically switches after a fixed interval.

The Skip Mode hotkeys are the four Arrow keys. Their operation is explained

in the table below:

Arrow Action

←

Skips from the current port to the first accessible port previous to it.

→

Skips from the current port to the first accessible port that comes after it.

↑

Skips from the current port to the very first accessible port on the

installation.

↓

Skips from the current port to the very last accessible port on the

installation.

1 2 ... 217 218 219 220 221 222 223 224 225 226 227 ... 283 284

Pas de commentaire

ATEN KN1108v Manuel d'utilisateur Page 222