ATEN CS-1732 Manuel d'utilisateur télécharger pdf (Page 18)

Hot Plugging

The Master View CS-1732A / CS-1734A supports USB hot plugging - components can

be removed and added back into the installation by unplugging their cables from the

CPU ports without the need to shut the unit down.

Powering Off and Restarting

If it becomes necessary to Power Off the Master View unit, before starting it back up

you must do the following:

1. Shut down all the computers that are attached to the switch.

Note: You must unplug the power cords of any computers that have the Keyboard

Power On function that are connected to the shut down switches. Otherwise,

the switches will still receive power from the computers.

2. Unplug the switch’s power adapter cable.

3. Wait 10 seconds, then plug the switch’s power adapter cable back in.

4. After the switch is up, Power On the computers.

Port Numbering

Each CPU port on the CS-1732A / CS-1734A switch is assigned a port number (1 or 2

for the CS-1732

A; 1 to 4 for the CS-1734A). The port numbers are marked on the rear

panel of the switch (see p. 7).

The Port ID of a computer is derived from the CPU port number it is connected to. For

example, a computer connected to CPU port 3 has a Port ID of 3.

The Port ID is used to specify which computer gets the KVM, USB hub, and audio

focus with the Hotkey port selection method (see p. 13, for details).

2005-12-21

CS-1732A / CS-1734A User Manual

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 36 37

Pas de commentaire

ATEN CS-1732 Manuel d'utilisateur Page 18