ATEN CS-1732 Manuel d'utilisateur télécharger pdf (Page 15)

Before you Begin

Cable Connection

To set up your Master View CS-1732A / CS-1734A installation, refer to the installation

diagrams on the following pages, and do the following:

1. Plug your USB keyboard and USB mouse into the USB Ports located on the unit’s

front panel.

2. Plug your monitor into the Console monitor port located on the unit’s rear panel.

3. Plug your microphone and speakers into the Console microphone and speaker jacks

located on the unit’s rear panel.

4. Using a KVM cable set (provided with this package), plug the custom SPDB

connector into any available CPU Port on the switch and plug the accompanying

microphone and speaker cables into the CPU Port’s microphone and speaker jacks.

Note: Be sure that all the plugs are are in the same CPU Port sockets (all in Port 1,

all in Port 2, etc.).

5. At the other end of the cable:

a) For a USB connection (see p. 11), plug the USB, video, microphone and speaker

cables into their respective ports on the computer.

b) For a PS/2 connection (see p. 11), plug the keyboard, mouse, video, microphone

and speaker cables into their respective ports on the computer.

Repeat steps 4 and 5 for any other computers you are connecting up.

2005-12-21

Hardware Setup

1. Make sure that power to all the devices you will be connecting up have

been turned off. You must unplug the power cords of any computers that

have the Keyboard Power On function. Otherwise, the switch will receive

power from the computer.

2. To prevent damage to your installation make sure that all devices on the

installation are properly grounded.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 36 37

Pas de commentaire

ATEN CS-1732 Manuel d'utilisateur Page 15