ATEN VE809 Manuel d'utilisateur télécharger pdf (Page 17)

Chapter 3

Operation

Overview

This chapter explains how to operate the VE809 HDMI Wireless Extender, IR

Blaster, IR Remote control, and EDID management.

Basic Operation

After installing the hardware, to begin using the VE809 HDMI Wireless

Extender, refer to the instructions below, and do the following:

1. Power On the Transmitter and Receiver.

2. The blue Power LED blinks on the Transmitter and Receiver until both

units are wirelessly connected.

It may take up to 20 seconds to establish the wireless connection.

3. From the Receiver side, turn the TV on and select the TV’s HDMI input

source for the VE809 Receiver’s connection.

4. From the Transmitter, turn on the source device(s) and press the Source

button (on top of the unit or from the remote control) to select the source

device you would like to use: HDMI 1 or HDMI 2.

5. With the Power LED on both units solid blue, video from the selected

source device will be broadcast on the remote HDTV connected to the

Receiver.

Note: If you don’t get a display on the TV connected to the Receiver, press

INFO on the VE809’s remote control , then refer to the on-screen display

(OSD) information, and see Troubleshooting, page 18 to resolve the issue.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 26 27

Pas de commentaire

ATEN VE809 Manuel d'utilisateur Page 17