ATEN PN7212 Manuel d'utilisateur Page 93

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 171
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 92
Chapter 7. Device Management
79
OOBC
In case the LAN that the Power Over the NET™ device resides on goes down,
or the it cannot be accessed with the usual browser based method for some
other reason, the device can be accessed via Out of Band methods utilizing the
its Console or Modem port.
The OOBC page is used to set up the serial configuration parameters for serial
terminal and modem Out of Band access to the Power Over the NET™ device,
as described in the sections that follow.
To operate the PN7212 / PN7320 from a local computer's console terminal
(HyperTerminal, GTKTerminal, etc.), connect the PN7212 / PN7320’s
Console port to the COM port of a local computer (see The PN7212 /
PN7320 can be installed in a 0U configuration on the side of a rack. To
rack mount the device, use the rack mounting brackets that came with your
device. The brackets can be mounted either near the top and bottom of the
back panel, or the top and bottom ends of the device (see page 12), as
shown in the diagrams below:, page 11, and Console Terminal Session,
page 115).
For dial in or dial back access, connect its Modem port to a modem (see
The PN7212 / PN7320 can be installed in a 0U configuration on the side
of a rack. To rack mount the device, use the rack mounting brackets that
came with your device. The brackets can be mounted either near the top
and bottom of the back panel, or the top and bottom ends of the device (see
page 12), as shown in the diagrams below:, page 11, and Modem Session,
page 119).
Console Port Settings
For serial terminal operation, this section sets the serial parameters of the
Power Over the NET™ device’s Console port.
Vue de la page 92
1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 170 171

Commentaires sur ces manuels

Pas de commentaire