ATEN VS0801H Manuel d'utilisateur télécharger pdf (Page 11)

- 11 -

Installation

Installation of the VS0801H is simply a matter of plugging in the

appropriate cables.

To install the switch, refer to the installation diagram on page 12

as you perform the following three steps:

1. Use an HDMI cable to connect the HDMI input port on the

video display device to the HDMI output port on the rear of

the VS0801H.

2. Use HDMI cables to connect the HDMI output ports on the

source device(s) to the HDMI input ports on the VS0801H.

Eight HDMI input ports are located on the rear of the switch.

3. Plug the provided power adapter into an appropriate AC

power source; plug the power adapter cable into the Power

Jack on the VS0801H.

This completes the basic installation of the VS0801H 8-port

HDMI Switch. You may now power on the display and source

devices.

Installing the RS-232 Controller

In order to use the RS-232 serial interface to attach a high-end

controller (such as a PC) to the VS0801H, use a serial cable such

as a modem cable. The end connecting to the VS0801H should

have a 9-pin male connector. Connect this to the serial interface

on the rear of the VS0801H. Refer to number 4 on the diagram

on page 12.

Note: To configure the controller serial port, see page 14.

1. Make sure that the power to all devices you will be

installing has been turned off.

2. Make sure that all devices you will be installing are

properly grounded.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

ATEN VS0801H Manuel d'utilisateur Page 11