ATEN UC-232A Manuel d'utilisateur

User ManualUC-232ARead this guide thoroughly and follow the installation and operation procedures carefully in order to prevent any damage to the unit

- 10 -Mac InstallationInstalling the SoftwareMac OS 91. Insert the installation disk into the CD-ROM drive.2. Open the CD-ROM Folder, then open the MA

- 11 -Linux InstallationInstalling the Driver(s)1. Insert the installation disk into your CD-ROM drive.2. Open a command line.3. Move to the CD-ROM di

- 12 -Uninstalling the Driver(s)1. Open a command line.2. Move to the directory where you installed the driver(s).3. Enter the following command: To

- 13 -Peripheral Installation1. After you have finished the software installation procedures for your operating system and have connected the UC-232A

- 14 -SpecificationsFunction SpecificationConnectors USB Type A PlugSerial DB-9 MaleLEDs Data Transfer / Handshaking (Orange)Data Transfer Rate Up to

- 15 -DB-9 Pin AssignmentsPin Assignment1CD2RXD3TXD4DTR5GND6DSR7RTS8CTS9RILimited WarrantyIN NO EVENT SHALL THE DIRECT VENDOR'S LIABILITY EXCEED

- 16 -This Page Intentionally Left Blank

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These lim

- 3 -OverviewUniversal Serial Bus (USB) port technology has emerged in response to the proliferation of external peripheral devices (scanners, digital

- 4 -System Requirements USB Host Controller installed on the systemOperating System Microsoft® Windows® 98, 2000, NT, XP or later Mac OS 9 or X R

- 5 -Windows InstallationInstalling the Driver(s)The installation disk included in the package contains Autorun software that will install the necessa

- 6 -3. Windows displays the following warning:You can safely ignore this warning.4. Click Continue Anyway to continue installing the new software. Wh

- 7 -Connecting the UC-232A1. Connect the UC-232A USB-to-Serial Converter to a USB port on your computer. The New Hardware Wizard appears: 2. Select N

- 8 -4. Windows displays the following warning: You can safely ignore this warning.5. Click Continue Anyway to continue installing the new hardware. W

- 9 -Uninstalling the Driver(s)1. Insert the installation disk into the CD-ROM drive. The follow-ing dialog box appears: 2. Select Uninstall the drive